Just loving the new Cipurvy Variety Bundle. Here you will see my creation with the Quite Curvy Stamp set— Beautiful Autumn Stamp and Autumn Punch paired with Gilded Autumn Designer Paper
Gather your supplies:
*1 piece of Cajun Craze card stock cut 4-1/4 x 11 scored and burnished at 5-1/2
(Your card will open right to left, landscape style.)
*2 pieces of Very Vanilla card stock measuring 4-1/8 x 5-3/8
*1 scrap piece of Very Vanilla Card stock
1 piece of Gilded Autumn DSP —I used the Pumpkin and Squash design that is primarily Cajun Craze in color with gold highlights.
Multiple scraps of Cajun Craze—copper and gold foil—card stock
*Punch out several leaves using your Autumn punch with the different scraps.
of the Foils.
*Stamp the maple leaf with Cajun Craze ink on Cajun Craze scraps—punch out with the Maple leaf punch.
*Stamp your Sentiment Using Itty Bitty Greeting—Tis The Season on a scrap piece of Very Vanilla Card stock and punch using the Banner punch ( or you can fussy cut). Also do a piece of the foil to match. Cut the foil piece in half and glue the ends to coordinate with the stamped piece. (Refer to the photo).
TIP: As mentioned you don’t always have to have all the dies and punches needed. Use any sentiment or punch you like that will work with the spade sign. Or just fussy cut.
*Stamp your inside greeting from Gather Together Stamp Set on the one of the large Very Vanilla piece and adhere to the inside of your base Card. Make sure you stamp and glue in the landscape fashion as in the picture.
* I stamped an acorn on Sahara Sand Card stock and punch and secured to the inside top left corner. This is optional.
To create your curved edge.
*With your DSP— align the filigree die so that the filagrees are on the bottom. Run it through your Die and Emboss Machine. You will then have 2 pieces. Your top piece will have a smooth clean curved edge. Your bottom piece will have a smooth curved edge with a filigree design just under the cut. (Refer to the photo)
*what you need to do now is take the bottom piece—dry check then secure to the other Very Vanilla card stock. You need to have that 1/8 in border. Dry check the top piece and trim off the top so that you will have a center curved area about 3/4 in in diameter. When you secure your top piece you will have a 1/8 in border all around.
** You can then align all your leaves in a quirky style line in the center. I popped mine up with mini dimensionals.
.*Cut a piece of the thin copper ribbon and wrap around the Very Vanilla and DSP piece. You can then secure to your card base. Take a 3-4 in extra piece of the same ribbon—thread the acorn trinket through and tie to the ribbon on the card. Add your sentiment piece to the bottom right corner.
TIP: I used several glue dots to anchor the ribbon as well as the sentiment to keep secure to the card.
That is it! Another very pretty autumn card!